DHV11 (M3104)
The DHV11, Module number M3104, is a Q-bus 8-line async serial card with DMA. It goes with several cabinet kits:
- CK-DHV11-AA - DHV CAB KIT FOR BA123,8 RS232 DATA LINES
- CK-DHV11-AC - Cab kit for DHV11,EIA,30"cable,shielded insert
- CK-DHV11-AF - DHV11 CAB KIT FOR SHIELDED H9642CAB,8 RS232 DATA
Because it can place a heavy load on the system, it needs a high priority on the bus. The preferred order for the usual Q-bus cards is, after the cpu and memory:
1. TSV05 9 track magtape controller
2. DMV11 Microprocessor controlled DECnet communications interface
3. TQK25 Controller for 8 inch magtape drive
4. DHV11 Microprocessor controlled communications multiplexor
5. DEQNA Ethernet controller
6. TQK50 Controller for single spindle cartridge magtape
7. RLV12 Controller for 14 inch RL series disk drives
8. RQDX3 Controller for 5 1/4 inch RD/RX drives
9. KDA50 Controller for 14 inch RA series disk drives
10. RQC25 Controller for 8 inch RC25 series disk drives
11. RQDX2 Controller for 5 1/4 inch RD/RX drives
12. DRV11-WA General purpose 22 bit DMA interface
The DHV11 has two banks of switches, 8 and 8, 16 total. Viewed from top of board with bus fingers at bottom, cables at top, the default settings are
0=OPEN
1=CLOSED
Bank 1: Bank 2: CSR
00001001 00011000 160440 300
switch # 12345678 12345678
Here follows 4 pages of documentation for the DHV11 in .jpg files. At the bottom
of the page is a link to the same information in .tif files.
They are a mirror of http://www.ezol.net/dec/dhv11/
For more details, check the Micronotes